Intelligent Provisioning 1.60 breaks 2008 R2 install (will not accept product key during setup)

By -
Intelligent Provisioning 1.60 breaks 2008 R2 install (will not accept product key during setup)

 On HP Proliant ML 310e V2 Gen8 / DL380p Gen8 servers to install 2008R2 /2014R2 using IP 1.60.  After the GUI for Windows setup starts, it fails on the autounattend.xml that IP 1.60 generates on the ProductKey.

After the setup fails it drops you back to a command prompt in WinPE


in the command prompt type the following command

notepad c:\autounattend.xml 

this will now open up autounattend.xml in notepad





now press ctrl + f and search for the string ProductKey





just below this string insert a new line contains the string "only the tags"
now save the file
then type the command to begin the installation process

x:\Windows\Hpssbem.exe 





installation will end fine :)

Comments

Post a Comment

Popular posts from this blog

Enable & Disable HP Dynamic Smart Array B120i & B320i Controllers

By -
Image
Enable and Disable HP Dynamic Smart Array B120i & B320i Controllers Press F9 to Enter RBSU “Rom Based Setup Utility”  System Options HP Dynamic Smart Array B120i / B320i RAID Controller   Enable for disable simply switch to Disable  "  Configuring HP Dynamic Smart Array B120i & B320i Controllers  " NOTE* “ if you need drivers while installing Windows Server on these servers go to this site and download it “ . http://cl.ly/1r2S2M1x0P0W 
Read more

HP SPP(Service Pack for Proliant) "2014.09" Released

By -
Image
HP SPP(Service Pack for Proliant)  "2014.09" Released HP SPP Page go here  www.hp.com/go/spp HP Service Pack for ProLiant (SPP) is a comprehensive systems software and firmware update solution, which is delivered as a single ISO image. This solution uses HP Smart Update Manager (HP SUM) as the deployment tool and is tested on all HP ProLiant Gen9, Gen8 and earlier servers as defined in the Service Pack for ProLiant Server Support Guide found at www.hp.com/go/spp/documentation .    This is the 3rd release in the this year , you can find details of previous versions here  SPP 2014.06.0   ,  SPP 2014.02.0(B)  , with the release of then Gen9 Proliant servers , there is a new version of "SPP" Service Pack for Proliant available , 2014.06.0 & 2014.02.0(B) were the old release this year , previous year release was SPP 2013.9(C) . Important Notes: This release no longer supports Red Hat Enterprise Li
Read more

How to upgrade your old Airtel sim to 4G

By -
Image
Go to  http://www.airtel.in/4g/sim-swap Request for your Free 4G SIM after you receive the sim you can find 20 digit sim no on the back side of sim packet or sim itself  send sms to 121 message as followed SMS YOUR20DIGITUNIQUESIMNUMBER you will get a message press 1 send to confirm  you will get a confirm message ,Now you have to wait until your network goes down  ,after network goes down you can swap with your NEW 4G SIM  go to settings and change your network to 4g  Enjoy 4G :) 
Read more