Enabling .Net Framework 3.5 in Windows Server 2012 using Command prompt

By -

Enabling .Net Framework 3.5 in Windows Server 2012 using Command prompt 


You need


  1. Media of Windows Server 2012

insert your media in your dvd drive or mound it via iLo or pendrive

please not your drive letter which is assigned to that media


now open up your command prompt

press windows key and R key same time now run windows will appear  , now  type CMD  then press enter 

this will open your command prompt

now mound your drive letter

in this case my drive letter is  "  D   "


so i need to type D: in the command prompt



now type following command

dism /online /enable-feature /featurename:NetFx3 /All /Source:d:/sources/sxs

Note*  in command line letter d may vary 

now wait for some time


done !

lets check on server manager




restart your server 

good luck 


Comments

Post a Comment

Popular posts from this blog

Enable & Disable HP Dynamic Smart Array B120i & B320i Controllers

By -
Image
Enable and Disable HP Dynamic Smart Array B120i & B320i Controllers Press F9 to Enter RBSU “Rom Based Setup Utility”  System Options HP Dynamic Smart Array B120i / B320i RAID Controller   Enable for disable simply switch to Disable  "  Configuring HP Dynamic Smart Array B120i & B320i Controllers  " NOTE* “ if you need drivers while installing Windows Server on these servers go to this site and download it “ . http://cl.ly/1r2S2M1x0P0W 
Read more

HP SPP(Service Pack for Proliant) "2014.09" Released

By -
Image
HP SPP(Service Pack for Proliant)  "2014.09" Released HP SPP Page go here  www.hp.com/go/spp HP Service Pack for ProLiant (SPP) is a comprehensive systems software and firmware update solution, which is delivered as a single ISO image. This solution uses HP Smart Update Manager (HP SUM) as the deployment tool and is tested on all HP ProLiant Gen9, Gen8 and earlier servers as defined in the Service Pack for ProLiant Server Support Guide found at www.hp.com/go/spp/documentation .    This is the 3rd release in the this year , you can find details of previous versions here  SPP 2014.06.0   ,  SPP 2014.02.0(B)  , with the release of then Gen9 Proliant servers , there is a new version of "SPP" Service Pack for Proliant available , 2014.06.0 & 2014.02.0(B) were the old release this year , previous year release was SPP 2013.9(C) . Important Notes: This release no longer supports Red Hat Enterprise Li
Read more

How to upgrade your old Airtel sim to 4G

By -
Image
Go to  http://www.airtel.in/4g/sim-swap Request for your Free 4G SIM after you receive the sim you can find 20 digit sim no on the back side of sim packet or sim itself  send sms to 121 message as followed SMS YOUR20DIGITUNIQUESIMNUMBER you will get a message press 1 send to confirm  you will get a confirm message ,Now you have to wait until your network goes down  ,after network goes down you can swap with your NEW 4G SIM  go to settings and change your network to 4g  Enjoy 4G :) 
Read more